MV
O ohw ;)
If you cut a hole in your bass drum head, use this!! It saved my head a few times already. A few years back I didn't see the use of this and I ended up with a torn bass drum head due to a kick mic falling over.
This is an easy to install solution in combination with the Bass Drum O's Cutter.
Better safe then sorry!!
This is an easy to install solution in combination with the Bass Drum O's Cutter.
Better safe then sorry!!
0
0
Report
EJ
Does exactly what it's supposed to do
Protects your port from ripping if there are any rough edges on your port cut. Gives a smooth edge and finishes of the look nicely.
Note: back mounting ring tends to pop off inside the shell but should not interfere with the stability of the O
Note: back mounting ring tends to pop off inside the shell but should not interfere with the stability of the O
0
0
Report
e
Works well
Easy to fit but be careful cutting your hole to make it a fraction bigger as mentioned on here before... It did take a bit of physical effort to make the two side s "click" together so make sure you do this properly otherwise will pop out one day!
0
0
Report
j
Solid
Does the job, a little fiddly to attach but worth it as it stays very secure. Some O rings are just an adhesive for the front side of the rest head but this one clips on both sides, which I prefer.
0
0
Report
A
very handy tool for bass drum sound enhancement
Very easy to install - enhances the sound of the bass drum thanks to more bass projection - I deliberately bought the 5 inch version because the bigger size compared to the 4 inch allows to put your hand into the bass drum to position whatever you use to muffle.
0
0
Report
A
Kick drum 5" plastic ring
Ring supplied with adhesive pads to hold both sides together.
Be sure to make hole 2-3mm larger - leaves room for 2 parts to click together easily.
Has improved the tone of the kick drum (less flap)
Plus, reduces the chance of tearing the front skin - always a risk when hitting it enthusiastically!!
Be sure to make hole 2-3mm larger - leaves room for 2 parts to click together easily.
Has improved the tone of the kick drum (less flap)
Plus, reduces the chance of tearing the front skin - always a risk when hitting it enthusiastically!!
0
0
Report
R
Does what it has to do
I've been using these for over then years now. Installing them can be a little tricky, but once installed you never have to worry about it again. An absolute must if you want a mic in your kick.
0
0
Report
JG
neat little thing
makes the hole in my bass drum skin look trim and neat. does a perfect job
0
0
Report
A
Good product
Easy to use. Making good looking my bass drum.
0
1
Report
BJ
Do the job very well
Yes not much can be said, but this one serve the purpose very well
0
0
Report