Warnex Structure Paint Black 1Kg

The paint does the job IF you apply it correctly. For touch ups it works well with a stipple application. To get the prickly, textured finish you need to work harder. Clearly spraying, and lots of paint quantity is the best. Roller application works pretty well, but best results are from a pre-coat if the timber is grained like plywood. Direct rolling onto bare ply can be a bit patchy. A overall thing hand brushed coat that just covers first is best. This will seal and fill most of the small voids or grain . Then a rolling with a foam roller, not the softer slightly hairy brushed. The foam rollers are quite stiff, instead of being soft, and if you use the narrower ones you can stick a decent amount of paint down on the first pass, then do a slightly lighter roll that picks up the surface and leaves the texture. You can get a really good finish if you do this - BUT - be aware you will use a LOT of paint. It goes down very quickly. it dries fast normally, but if you use it outside on a sunny day it dries too quickly and it's difficult to not get a patchy result. I have not tried using it in the cold. It is very thick and sticky paint, and while being water soluble for cleaning, it relies on the brushes and rollers being wet - and as soon as they have started to dry, you won't get them clean, so use cheap brushes and rollers and throw them away. Small point but if you have can in the workshop to use as touch ups as I do, be aware the can is quite thin and repeated opening and closing can leave gaps int he seal and this paint goes off very quickly if air gets to it.